Removing The Library From A Desktop Kit; Figure 56 Installing Top Cover - Quantum Scalar i40 User Manual

Chapter 9: Installing, Removing, and Replacing Components

Removing the Library from a Desktop Kit

Figure 56 Installing Top Cover

Removing the Library from a Desktop Kit
252
8 Install the top cover as follows (see
a Slide the top cover onto the library, from back to front. The back
of the top cover has two screw holes and overhangs the back of
the library.
b Install the two top cover screws through the top cover and into
the screw holes in the top of the side panels.
9 Re-install the magazines and push them in until they close.
10 Re-install tape drives if you removed them previously.
11 Connect the tape drive cables, Ethernet cable, and power cord (see
Connecting Library Cables
To remove the library from a desktop kit, reverse the steps in
the Library in a Desktop Kit
Figure 56):
on page 227).
on page 244.
Quantum Scalar i40 and Scalar i80 User's Guide
Installing