Appendix D Repacking The Scalar 50 Library; Removing The Library From The Rack - Quantum Scalar 50 User Manual

Removing the Library from the Rack

Quantum Scalar 50 User's Guide
To remove the Scalar 50 library from the rack:
Note: You must remove all tape cartridges from the library prior
to parking the library robotics for shipment.
1 Using the OCP, open the front doors, remove both tape cartridge
magazines, and remove any tape cartridges from the fixed bins or
FlexLink™ (refer to the Quantum Scalar 50 User's Guide PN 81-81768
for information on OCP operation and bin locations).
After removing the tape cartridge magazines and closing the doors,
the library inventories all possible tape cartridge locations
(magazines, fixed slots, Flexlink, and tape drives). This process takes
several minutes.
2 From the
Library Operations
. The library shuts down automatically.
Shipping
Note: If there are tape cartridges in the library, the system will
NOT park the library robotics. You must remove all tape
cartridges from the system prior to parking the library
robotics.
3 From the back of the library, disconnect all power, Ethernet, and SCSI
cables from the library and note their locations for later reinstallation.
Warning: This unit has more than one power supply cord.
Disconnect all power supply cords before servicing to
avoid electric shock.
4 To remove the library chassis from the rack (see
Note: Refer to the Scalar 50 Quick Start Guide (PN 81-81767) for
additional Scalar 50 rack mount information.
Loosen the captive screws securing the tape drives to the chassis
f
and remove the tape drive(s) from the back of the library.

Appendix D Repacking the Scalar 50 Library

Removing the Library from the Rack
screen on the OCP, select
figure
4
Park for
124):
217