Figure 59 Scalar I80 Pull/Push Locations - Quantum Scalar i40 User Manual

Figure 59 Scalar i80 Pull/Push
Locations
Quantum Scalar i40 and Scalar i80 User's Guide
Chapter 9: Installing, Removing, and Replacing Components
Pull in this area
when removing
bezel. Push in
this area when
installing bezel.
9 Install the new bezel straight onto the library. Do not tip or twist the
bezel. If magazines are still in the library, be careful not to scratch or
damage the bezel as you install it. Slide the top and bottom edges
of the bezel to the inside of the top and bottom layers of the chassis
sheet metal. On the Scalar i80, press in near the center on both
sides of the bezel until you hear it "snap" into place (see
for locations).
Caution: Make sure the power button and all four operator
panel control buttons appear through the holes in the
bezel and are not trapped beneath the bezel.
Caution: Be careful not to accidentally hit the power button and
turn the library off while you are installing the bezel.
10 Install the two top screws, then the two bottom screws.
11 Reinstall the library in the rack or desktop kit.
12 Close all the magazines.
13 If you turned the library off to perform this procedure, turn it ON
now by pressing the power button on the front panel. Wait until the
library initializes before resuming library operations.
Removing and Replacing the Front Bezel
Pull in this area
when removing
bezel. Push in
this area when
installing bezel.
Figure 59
257