Deleting Tape Drive Firmware Used In Autoleveling - Quantum Scalar i40 User Manual

Chapter 10: Updating Firmware
Updating and Autoleveling Tape Drive Firmware
308
Note: Deleting tape drive firmware for autoleveling only deletes the
firmware and makes the library's baseline tape drive firmware
available for autoleveling. It does not initiate autoleveling or
install firmware on the tape drives. To initiate autoleveling, see
Initiating Tape Drive Firmware Autoleveling
You can only delete tape drive firmware on the Web client.
Web Client
1 Select Tools > Drive Operations.
The Tools - Drive Operations screen displays.
2 Select Upload/remove tape drive firmware for autoleveling and
click Next.
The Tape Drive Firmware Autolevel screen displays. The screen lists
the vendor, type, interface type, form factor, and firmware revision
number for all tape drives that the library supports, whether or not
they are installed in the library.
3 Select the tape drive firmware you want to delete.
4 Click Delete.
The Progress Window displays. The Progress Window contains
information on the action, elapsed time, and status of the
requested operation. Do one of the following:
• If Success appears in the Progress Window, the tape drive
firmware was successfully deleted. The library's default baseline
tape drive firmware will now be used for autoleveling.
• If Failure appears in the Progress Window, the tape drive
firmware update was not successfully deleted.
5 To initiate autoleveling, see
Autoleveling on page 310.
Initiating Tape Drive Firmware
Quantum Scalar i40 and Scalar i80 User's Guide
on page 310.