Removing The Magazine From The Library - Quantum Scalar i40 User Manual

Chapter 9: Installing, Removing, and Replacing Components
Removing and Replacing a Magazine
Removing the
Magazine from the
Library
272
3 Click the "print" icon in the upper right corner to print the report.
Alternatively, take a screen capture of the report and save or print it,
or copy the map by hand.
You can perform this procedure with library power on.
1 From the operator panel, select Actions > Magazine.
2 Use the Up and Down buttons to select the magazine you want to
remove and press Release.
3 Wait for the operator panel to display the message: "Magazine is
now unlocked. Waiting for the magazine to be moved to the
expected position."
4 Pull out on the magazine bezel handle and remove the magazine
from the library. If you do not remove the magazine within 30
seconds, the magazine locks again.
Note: If the library is turned off, you can release the magazine
manually by inserting an opened paperclip, small screwdriver,
or other object (3.5 mm or less in diameter that will not break
off) into the access hole in the bottom of the magazine bezel
(see Figure 65). Use the tool to depress the release latch while
gently pulling outward on the magazine bezel handle.
Right-side magazines will only slide out as far as the I/E station.
To release right-side magazines fully:
– On the Scalar i40 and the bottom right magazine of the
Scalar i80, reach under the open magazine and insert the tool
directly into the access hole in the library chassis to depress the
release latch, while pulling out on the magazine bezel handle.
– On the top right magazine of the Scalar i80, reach under the
open magazine and press the release latch directly with your
finger, while pulling out on the magazine bezel handle.
Quantum Scalar i40 and Scalar i80 User's Guide