Figure 53 Magazine Release Latch Access Holes - Quantum Scalar i40 User Manual

Chapter 9: Installing, Removing, and Replacing Components
Installing the Library in a Desktop Kit
Figure 53 Magazine Release
Latch Access Holes
248
Magazine release latch access holes
4 Look through the magazine slot openings to be sure the Y-tray is
resting on the floor of the library. If not, reach inside and gently
press down on one of the Y-tray's side metal rods until the Y-tray
starts moving. It should drift down to rest on the floor of the library.
5 Turn the library carefully on its side (either the left or right side).
Make sure the front end of the library (the "rack ear") overhangs the
edge of the table so that the library lies flat.
6 Install the eight rubber feet on the bottom of the library, as follows:
a There are eight holes in the bottom of the library into which you
will press the rubber feet. Four holes are located along the right
edge and four along the left edge.
locations of these holes.
b Use your fingers to press the feet into the holes. Twisting the
feet as you push them may make it easier to get them in. See
Figure 54 on page 249.
c Carefully turn the library back to an upright position so that it is
resting on its rubber feet.
Figure 54
Quantum Scalar i40 and Scalar i80 User's Guide
shows the