Robotics Get/Put Test - Quantum Scalar i40 User Manual

Chapter 11: Troubleshooting
Performing Library Diagnostics

Robotics Get/Put Test

332
Web Client
1 Enter Diagnostics (
partitions offline and log out all other users of the same or lower
privileges).
2 Select
Drives > Drive Tests > Drive Reset
3 If the tape drives are assigned to more than one partition, select the
partition in which the tape drive(s) you want to reset are located.
Select Unassigned if the tape drive(s) you want to reset are not
assigned to a partition. Click Next.
4 Select the tape drive(s) you want to reset.
5 Click Apply.
6 The test runs. When complete, a "success" or "failure" message
displays.
The Get/Put Test requires the robot to remove one tape cartridge from
the top I/E station slot, and then put the tape cartridge back into the
same slot. To run this test, you must insert a tape into the library's top
(uppermost) I/E station slot.
You can only perform this test from the Web client, by entering
Diagnostics (see Performing Library Diagnostics
Web Client
1 Install a scratch tape in the top I/E station slot.
2 If manual cartridge assignment is enabled, assign the scratch tape
to the System partition.
3 Enter Diagnostics (
partitions offline and log out all other users of the same or lower
privileges).
4 Select
Robotics > Robotics Get/Put Test
5 Click Apply.
6 The test runs. When complete, a "success" or "failure" message
displays.
, then click OK to take
Tools > Diagnostics
.
, then click OK to take
Tools > Diagnostics
.
Quantum Scalar i40 and Scalar i80 User's Guide
on page 330).