Removing The Library From The Pallet; Figure 9 Rolling The Library Off The Pallet - Quantum ACL 4/52 Installation Manual

Automated tape library for dlt cartridges
Hide thumbs Also See for ACL 4/52:
Table of Contents

Advertisement

Figure 9 Rolling the
Library Off the Pallet

Removing the Library from the Pallet

Caution: The library weighs approximately 335 pounds. It is
recommended that at least two individuals perform the
following procedure.
To remove the library from the pallet:
1 Verify that all leveling feet (located on the underside of the library
at each corner of the cabinet) at in the up position.
If they are not, rotate each foot clockwise until it is fully retracted.
2 Guide the library out of the shipping bag and down the ramp (see
figure 9).
If two persons are available to do this, one should be positioned at
the front of the library to guide it down the ramp while another is
positioned at the back of the library to push the library forward.
Note: If you are the only person available to perform this procedure,
position yourself in front of the library so you can pull it
forward onto the ramp and carefully guide it to the floor. The
two-person procedure is recommended.
3 Save the shipping bag for future use.
ACL 4/52 Facilities Planning and Installation Guide
Chapter 2 Unpacking the Library
Removing the Library from the Pallet
TA00138a
2
9

Advertisement

Table of Contents
loading

Table of Contents