Configuring Security Settings; Network Interface - Quantum Scalar i40 User Manual

Configuring Security Settings

Network Interface

Quantum Scalar i40 and Scalar i80 User's Guide
You can enable/disable the following security settings on the operator
panel:
• Network Interface
• SSH Services
• Internet Control Message Protocol (ICMP)
• Remote Access Via Web Client
• Remote Service Login
• SNMP V1/V2
• SSL
Enables or disables all external access to the library. This setting is
enabled by default to allow external access.
Operator Panel
1 Select Setup > Security Services > Network IF.
2 Press Modify.
3 Use the Up and Down buttons to select Enabled or Disabled and
press Apply.
4 Make another selection or press Exit.
5 Save the library configuration (see
on page 107).
Chapter 4: Configuring the Library
Configuring Security Settings
Saving the Library Configuration
103