Setting The Date, Time, And Time Zone - Quantum Scalar i40 User Manual

Chapter 4: Configuring the Library

Setting the Date, Time, and Time Zone

Setting the Date, Time, and Time Zone
48
For more information about the library MIB, see the
Scalar i80 Basic SNMP Reference Guide
Quantum Support.
For information on integrating MIBs with an SNMP management
application, contact your network management application vendor.
Web Client
1 Select Tools > Download SNMP MIB.
2 Save the file to a known location.
You can either set the library date, time, and time zone settings
manually or configure the Network Time Protocol (NTP). NTP allows you
to synchronize the library date and time with other components in your
IT infrastructure.
If you enable NTP, you must also configure the IP address of at least one
NTP server. Contact your network administrator for NTP server IP address
information.
You can configure the date and time on both the operator panel and
the Web client. You can view the time zone on the operator panel, but
must use the Web client to change it. You can only configure NTP
settings on the Web client.
Note: The following operations should not be performed
concurrently by multiple administrators logged in from
different locations. You can access the appropriate screens, but
you cannot apply changes while another administrator is
performing the same operation.
(6-66773-xx) or contact
Quantum Scalar i40 and Scalar i80 User's Guide
Scalar i40 and