Logical Serial Number Addressing - Quantum Scalar i40 User Manual

Logical Serial Number
Addressing
Quantum Scalar i40 and Scalar i80 User's Guide
4 Make another selection or press Exit.
5 Save the library configuration (see
on page 107).
The library uses the actual tape drive serial numbers by default (logical
SN addressing is disabled). Enabling logical SN addressing enables the
library to assign logical serial numbers to all tape drives in the library.
Specifically, the library assigns a logical serial number to a tape drive in a
specific location, not the serial number of the particular tape drive. If
the tape drive is then replaced by another tape drive in the same library
location, the logical serial number remains the same. From the host
application's perspective, the replacement tape drive is the same as the
original. This setting is disabled by default.
Caution: If you change the logical serial number addressing setting,
you must power cycle the library (perform a shutdown and
press the power button) or remove and replace each tape
drive in the library in order for the change to take effect.
Operator Panel
1 Select Setup > System Settings > Logical SN Addr.
2 Press Modify.
3 Use the Up and Down buttons to select Enabled or Disabled and
press Apply.
4 Make another selection or press Exit.
5 Power cycle the library.
6 Save the library configuration (see
on page 107).
Chapter 4: Configuring the Library
Configuring System Settings
Saving the Library Configuration
Saving the Library Configuration
99