Figure 64 Filler Plates Installed - Quantum Scalar i40 User Manual

Chapter 9: Installing, Removing, and Replacing Components
Removing and Installing a Filler Plate

Figure 64 Filler Plates Installed

270
3 Lift the filler plate up to disengage the catch at the bottom and pull
the filler plate out of the slot.
Installing a power supply filler plate:
• On the Scalar i80, if you are using only one power supply, you
should install the power supply in the upper slot, and cover the
lower slot with a filler plate (see
1 Hold the filler plate with the thumbscrews at the top.
2 Insert the bottom edge of the filler plate into the slot, engaging the
bottom edge of the filler plate into the bottom of the slot.
3 Pivot the filler plate up to fit securely in the hole.
4 Tighten the thumbscrews.
Tape drive filler plate
Figure 64 on page 270).
Quantum Scalar i40 and Scalar i80 User's Guide
Single
power
supply
installed
in top
slot
Power
supply
filler
plate