Configuring An Aggregation Group; Configuring A Static Aggregation Group - HP 4800G Series Configuration Manual

Configuring an Aggregation Group

The following ports cannot be assigned to an aggregation group: Stack ports, RRPP-enabled ports,
MAC address authentication-enabled ports, port security-enabled ports, IP source guard-enabled
ports, and 802.1x-enabled ports.
You are recommended not to assign reflector ports of port mirroring to an aggregation group. For
details about reflector ports, refer to Port Mirroring Configuration in the Access Volume.

Configuring a Static Aggregation Group

Follow these steps to configure a Layer 2 static aggregation group:
To do...
Enter system view
Create a Layer 2
aggregate interface and
enter the Layer 2
aggregate interface view
Exit to system view
Enter Ethernet interface
view
Assign the Ethernet
interface to the
aggregation group
Removing a Layer 2 aggregate interface also removes the corresponding aggregation group. At
the same time, the member ports of the aggregation group, if any, leave the aggregation group.
To guarantee a successful static aggregation, ensure that the ports at the two ends of each link to
be aggregated are consistent in the selected/unselected state.
Use the command...
system-view
interface bridge-aggregation
interface-number
quit
interface interface-type
interface-number
port link-aggregation group number
1-6
Remarks
—
Required
When you create a Layer 2
aggregate interface, a Layer 2
static aggregation group
numbered the same is created
automatically.
—
Required
Repeat the two steps to assign
multiple Ethernet interfaces to
the aggregation group.