Meanwhile, the system with the higher system ID, which has identified the aggregation state changes on
the remote system, sets the aggregation state of local member ports as the same as their peer ports.
NOTE:
To ensure stable aggregation state and service continuity, do not change port attributes or class-two
•
configurations on any member port.
In a dynamic aggregation group, when the aggregation state of a local port changes, the aggregation
•
state of the peer port changes.
•
A port that joins a dynamic aggregation group after the Selected port limit has been reached will be
placed in the Selected state if it is more eligible for being selected than a current member port.
Load-sharing criteria for link aggregation groups
In a link aggregation group, traffic can be load-shared across the selected member ports based on a set
of criteria, depending on your configuration.
You can choose one of the following criteria or any combination of them for load sharing:
MAC addresses
•
IP addresses
•
Ethernet link aggregation configuration task list
Complete the following tasks to configure Ethernet link aggregation:
Task
Configuring an
aggregation
group
Configuring an
aggregate
interface
Configuring load sharing for link aggregation groups
Configuring an aggregation group
Configuration guidelines
You cannot assign a port to a Layer 2 aggregation group if any of the features listed in
configured on the port.
Configuring a static aggregation group
Configuring a dynamic aggregation group
Configuring the description of an aggregate interface
Enabling link state traps for an aggregate interface
Setting the minimum number of Selected ports for an
aggregation group
Shutting down an aggregate interface
Restoring the default settings for an aggregate interface
32
Remarks
Select either task
Optional
Optional
Optional
Optional
Optional
Optional
Table 6
is