Load Sharing Mode Of An Aggregation Group; Link Aggregation Configuration Task List - HP 4800G Series Configuration Manual

For static and dynamic aggregation modes:
In an aggregation group, the port to be a selected port must be the same as the reference port in
port attributes, and class-two configurations. To keep these configurations consistent, you should
configure the port manually.
Because changing a port attribute or class-two configuration setting of a port may cause the select
state of the port and other member ports to change and thus affects services, you are
recommended to do that with caution.

Load Sharing Mode of an Aggregation Group

The link aggregation groups created on the 3Com Switch 4800G always operates in load sharing mode,
even when they contain only one member port.

Link Aggregation Configuration Task List

Complete the following tasks to configure link aggregation:
Configuring an
Aggregation Group
Configuring an
Aggregate Interface
Configuring a Load Sharing Mode for Load-Sharing Link Aggregation
Groups
Task
Configuring a Static Aggregation Group
Configuring a Dynamic Aggregation Group
Configuring the Description of an Aggregate
Interface
Enabling LinkUp/LinkDown Trap Generation
for an Aggregate Interface
Shutting Down an Aggregate Interface
1-5
Remarks
Required
Perform either of the tasks
Optional
Optional
Optional
Optional