H3C S5100-SI Operation Manual page 461

GigabitEthernet1/0/2
mirroring mac:
mirroring vlan:
reflector port: GigabitEthernet1/0/4
remote-probe vlan: 10
2) Configure the intermediate switch (Switch B)
# Configure VLAN 10 as the remote-probe VLAN.
<Sysname> system-view
[Sysname] vlan 10
[Sysname-vlan10] remote-probe vlan enable
[Sysname-vlan10] quit
# Configure GigabitEthernet 1/0/1 as the trunk port, allowing packets of VLAN 10 to pass.
[Sysname] interface GigabitEthernet 1/0/1
[Sysname-GigabitEthernet1/0/1] port link-type trunk
[Sysname-GigabitEthernet1/0/1] port trunk permit vlan 10
[Sysname-GigabitEthernet1/0/1] quit
# Configure GigabitEthernet 1/0/2 as the trunk port, allowing packets of VLAN 10 to pass.
[Sysname] interface GigabitEthernet 1/0/2
[Sysname-GigabitEthernet1/0/2] port link-type trunk
[Sysname-GigabitEthernet1/0/2] port trunk permit vlan 10
3) Configure the destination switch (Switch C)
# Create remote destination mirroring group 1.
<Sysname> system-view
[Sysname] mirroring-group 1 remote-destination
# Configure VLAN 10 as the remote-probe VLAN.
[Sysname] vlan 10
[Sysname-vlan10] remote-probe vlan enable
[Sysname-vlan10] quit
# Configure the destination port and remote-probe VLAN for the remote destination
mirroring group.
[Sysname] mirroring-group 1 monitor-port GigabitEthernet 1/0/2
[Sysname] mirroring-group 1 remote-probe vlan 10
# Configure GigabitEthernet 1/0/1 as the trunk port, allowing packets of VLAN 10 to pass.
[Sysname] interface GigabitEthernet 1/0/1
[Sysname-GigabitEthernet1/0/1] port link-type trunk
[Sysname-GigabitEthernet1/0/1] port trunk permit vlan 10
[Sysname-GigabitEthernet1/0/1] quit
# Display configuration information about remote destination mirroring group 1.
[Sysname] display mirroring-group 1
mirroring-group 1:
inbound
1-14