Access Control List; Ip Filter Setup - TRENDnet 14dBi User Manual

5.2 Access Control List

5.2.1 IP Filter Setup

Allows to create deny or allow rules to filter ingress or egress packets from specific source and/or to
destination IP address on wired (LAN) or Wireless (WAN) ports. Filter rules could be used to filter unicast or
multicast packets on different protocols as shown in the IP Filter Setup. Important to note that IP filter rules
has precedence over Virtual server rules.
Please click on Advance -> IP Filter Setup and follow the below setting.
Source Address/Mask : Enter desired source IP address and netmask; i.e. 192.168.2.10/32.

Source Port : Enter a port or a range of ports as start:end; i.e. port 20:80

Destination Address/Mask : Enter desired destination IP address and netmask; i.e. 192.168.1.10/32

Destination Port : Enter a port or a range of ports as start:end; i.e. port 20:80

In/Out : Applies to Ingress or egress packets

Protocol : Supports TCP, UDP or ICMP.

Listen : Click Yes radial button to match TCP packets only with the SYN flag.

TEW-455APBO High Power Wireless Outdoor PoE Access Point
68
User Manual