Setting Up Advanced Event Filtering For A User - Brocade Communications Systems Brocade BladeSystem 4/24 User Manual

10
8. Enter the length of time the application should wait between notifications in the Summary
9. Select one of the following options:
10. Click Send Test E-mail to test the e-mail server.
11. Click OK to save your work and close the E-mail Event Notification Setup dialog box.

Setting up advanced event filtering for a user

To set up advanced event filtering on the selected events for a user, complete the following steps.
1. Select Server > Users.
2. Select a user in the Users table and click Edit.
3. Select the E-mail Notification Enable check box and click the Filter link.
4. Click Advanced Filtering.
5. Click the Include Events tab.
274
Interval field and list.
Notifications are combined into a single e-mail and sent at each interval setting. An interval
setting of zero causes notifications to be sent immediately.
ATTENTION
Setting too short an interval can cause the recipient's e-mail inbox to fill very quickly.
•
Select Send to and enter an e-mail address for a user to send a test e-mail to a specific
user.
•
Select Send to all users enabled for notification to send a test e-mail to all users already
set to receive notification.
A message displays whether the server was found. If the server was not found, verify that the
server address was entered correctly and that the server is running. If you are using an SMTP
mail server, also verify that the SMTP ID and password information was entered correctly.
The Server Users dialog box displays.
The Edit User dialog box displays.
The Define Filter dialog box displays.
The Advanced Event Filtering dialog box displays.
DCFM Professional Plus User Manual
53-1001774-01