Creating A New Lsan Zone - Brocade Communications Systems Brocade BladeSystem 4/24 User Manual

7.
8. Review the information in this dialog box.
9. Click OK to activate the LSAN zones and close the dialog box.
10. Click OK to continue.
11. Click OK to close the dialog box.

Creating a new LSAN zone

1. Select a backbone fabric from the Connectivity Map or Product List.
2. Select Configure > Zoning > LSAN Zoning (Device Sharing).
3. Click the Zone DB tab if that tab is not automatically displayed.
4. Click New Zone.
5. Enter a name for the zone.
6. Press Enter.
7.
8. Review the information in this dialog box.
9. Click OK to activate the LSAN zones.
DCFM Professional Plus User Manual
53-1001774-01
NOTE
You cannot add an LSAN zone to a zone configuration.
Click Activate.
The Activate LSAN Zones dialog box displays.
A message box displays informing you that the zones you change will be saved in the zone
database and asking whether you want to proceed. Click Yes to confirm the activation, or No to
cancel the activation.
When you click Yes, a busy window displays indicating the activation is in progress. A status
field informs you whether the activation succeeded or failed. When it succeeds, icons for the
active zone configuration and its zones display green. When it fails, the message includes the
reason for the failure.
All LSAN zones are activated on the selected fabrics and saved to the Zone DB.
The Zoning dialog box displays.
The prefix LSAN_ is automatically added in the text field.
For zone name requirements and limitations, refer to
page 569.
Depending on the characters included in the name you enter, a message may display
informing you the name contains characters that are not accepted by some switch vendors,
and asking whether you want to proceed. Click Yes to continue, or No to cancel the zone
creation.
Click Activate.
The Activate LSAN Zones dialog box displays.
"Zoning naming conventions"
20
on
591