Editing A Cee Map - Brocade Communications Systems Brocade BladeSystem 4/24 User Manual

15

Editing a CEE map

1. Select Configure > Switch > CEE from the menu bar.
2. Select a switch, and click Edit.
3. Click the QoS tab on the Edit Switch dialog box.
4. Select a CEE Map from the CEE Maps table, and click the left arrow button to load its values to
5. Keep the same CEE Map name and modify the following values, as required. See
6. Click the right arrow button to re-add the map to the CEE Maps table.
7.
8. Review the changes carefully before you accept them.
9. Click Start to apply the changes, or click Close to abort the operation. If any configuration
376
The CEE Configuration dialog box displays, showing the status of all CEE-related hardware and
functions.
The QoS dialog box displays.
the left pane. The fields are now editable.
an example of priority group configuration.
•
Name - Enter a name to identify the CEE map. If the switch is a 10 Gbps CEE/FC switch
module, you cannot change the name.
•
Precedence - Enter a value between 1 - 100. This number determines the map's priority.
•
% Bandwidth - Enter a bandwidth value for priority group IDs 0-7. The total of all priority
groups must equal 100%.
•
Priority Flow Control check box - Check to enable priority flow control on individual priority
groups.
•
CoS - Enter a Class of Service value to correspond to the Priority Group ID rows. Each CoS
must be mapped to at least one of the Priority Group IDs (0-7), separated with a comma
and a space, as shown in
If the CEE Map already exists, an overwrite message displays.
Click OK.
The CEE Confirmation and Status dialog box displays.
errors exist in the CEE map, an error message displays in the Status area.
Figure 115.
Table 23
DCFM Professional Plus User Manual
53-1001774-01
for