Editing A Cee Port - Brocade Communications Systems Brocade BladeSystem 4/24 User Manual

15

Editing a CEE port

1. Select Configure > Switch > CEE from the menu bar.
2. Select a CEE port from the Products/Ports table.
3. Click Edit.
FIGURE 111
4. Modify the following CEE Port parameters as required:
366
The CEE Configuration dialog box displays, showing the status of all CEE-related hardware and
functions.
The Edit Port dialog box displays.
Edit Port dialog box
•
Status - Enable or Disable. You must enable the LAG to use the CEE functionality.
•
Interface Mode - None or L2. For external ports, the L3 interface mode displays, in addition
to None or L2. If you select L3 as the interface mode, the IP/Netmask field is enabled and
you can then assign the primary and secondary IP addresses.
L2 Mode - This is enabled if you select L2 as the Interface Mode. If a CEE port is

enabled on the 10 Gbps CEE/FC switch module, the L2 mode is disabled.
L3 Mode appears only for the 10 Gbps CEE/FC switch module port.

NOTE
You cannot change the Interface Mode to None if it is set to L2 and the port is assigned to
a VLAN.
•
IP/Netmask - The netmask is used to divide an IP address into subnets. It specifies which
portion of the IP address represents the network and which portion represents the host,
and can only be configured if the interface mode is L3.
Primary - The primary IP address assigned to a 10 Gbps CEE/FC switch module.

Secondary - The secondary IP address is optional. Secondary IP addresses are helpful

when the interface port is part of multiple subnets.
DCFM Professional Plus User Manual
53-1001774-01