Duplicating A Security Violation Policy - Brocade Communications Systems Brocade BladeSystem 4/24 User Manual

10
11. Select the Active check box to activate the duplicated policy.
12. Click OK on the Event Policies dialog box.

Duplicating a security violation policy

To duplicate a security violation policy, complete the following steps.
1. Select Monitor > Event Policies.
2. Select the policy you want to duplicate in the Policies table.
3. Click Duplicate.
4. Enter a name (255 characters maximum) for the policy in the Name field.
5. Define the trigger in the IP Address, Node WWN, and Name list.
6. Enter a value (between 2 and 999) in the Count field.
7.
8. Select the duration type (Seconds or Minutes) from the Duration list.
9. Select the check box in the Actions list for each action you want to occur when this policy is
10. Click OK on the Add Event Policy dialog box.
11. Select the Active check box to activate the duplicated policy.
12. Click OK on the Event Policies dialog box.
268
The Event Policies dialog box displays.
The Duplicate Event Policy dialog box displays.
Policy names must be unique; however, they are case insensitive.
The trigger is limited to 1024 characters. Multiple values must be separated by a semi-colon.
When multiple values are entered, as long as at least one value matches the IP address, Node
WWN, or Name in the event and all other conditions are met, an action is triggered.
IP addresses can either be in IPv4 or IPv6 format and must be complete.
A Node WWN is accepted with or without the colon.
Enter a value (between 1 and 999) in the Duration field.
The maximum duration is 30 minutes.
triggered.
For a list of the available actions, refer to
refer to "Defining the broadcast message action"
action" on page 262, "Defining the send e-mail action"
data capture action" on page 264.
"Policy actions" on page 257. To define an action,
on page 261, "Defining the launch script
on page 263, or
DCFM Professional Plus User Manual
"Configuring support
53-1001774-01