Creating A New Encryption Group - Brocade Communications Systems Brocade BladeSystem 4/24 User Manual

18

Creating a new encryption group

The following steps describe how to start and run the encryption setup wizard, and then create a
new encryption group.
NOTE
When a new encryption group is created, any existing tape pools in the switch are removed.
1. Select Configure > Encryption from the menu bar.
FIGURE 162
2. Select a switch from the <NO GROUP DEFINED> encryption group. The switch must not be in
3. Select a switch and select Encryption > Create/Add to Group, from the menu bar, or right-click
486
The Encryption Center dialog box displays.
Encryption Center - No Group Defined dialog box
an encryption group already.
the switch and select Create/Add to Group.
The Configure Switch Encryption welcome panel displays.
DCFM Professional Plus User Manual
53-1001774-01