Snmp Trap And Informs Registration And Forwarding; Registering The Management Server; Registering A Different Management Application Server - Brocade Communications Systems Brocade BladeSystem 4/24 User Manual

Supporting dcfm 10.4.x
Hide thumbs Also See for Brocade BladeSystem 4/24:
Table of Contents

Advertisement

SNMP trap and informs registration and forwarding

You can configure the application to send SNMP traps and informs to other computers. To correctly
configure trap forwarding, you must configure the target computer's IP address and SNMP ports. To
correctly configure informs, you must enable informs on the switch.

Registering the management server

NOTE
If the source IP address does not match the switch, the Management application does not forward
the SNMP traps.
NOTE
SNMP Informs is only supported on Fabric OS 6.3 or later switches discovered through SNMP v3. For
information about discovery through SNMP v3, refer to
You can automatically register this server as the trap or informs recipient on all managed Fabric OS
devices.
To register the management server, complete the following steps.
1. Select Monitor > SNMP Setup.
2. Click the Management Server tab.
3. Select the Auto register server as SNMP trap or informs recipient check box, if necessary.
4. Enter the SNMP listening port number of the Server in the SNMP Listening Port (Server) field, if
5. Click OK on the SNMP Setup dialog box.

Registering a different Management application server

You can register any Management application server as the trap recipient on managed Fabric OS
devices. You can register different recipients for different fabrics.
To register a host server, complete the following steps.
1. Select Monitor > SNMP Setup.
2. Click the Other Recipients tab.
3. Select Add from the Action list.
4. Enter the IP address (IPv4 or IPv6 format) of the host server in the Recipient Server IP Address
DCFM Professional Plus User Manual
53-1001774-01
The SNMP Setup dialog box displays.
This check box is selected by default.
necessary.
The default SNMP listening port number is 162 and is automatically populated.
The SNMP Setup dialog box displays.
field.
"Discovering fabrics"
on page 36.
10
277

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dcfm professional plus

Table of Contents