Display Rrpp Ring-Group - HP 6125G Command Reference Manual

2 1
Table 21 Command output
Field
Flags for Node Mode
RRPP Protocol Status
Number of RRPP Domains
Domain ID
Control VLAN
Protected VLAN
Hello Timer
Fail Timer
Ring ID
Ring Level
Node Mode
Primary/Common Port
Secondary/Edge Port
Enable Status

display rrpp ring-group

Syntax
display rrpp ring-group [ ring-group-id ] [ | { begin | exclude | include } regular-expression ]
E GE1/0/3
GE1/0/4
Description
RRPP node mode:
•
M represents master node.
•
T represents transit node.
•
E represents edge node.
•
A represents assistant edge node.
RRPP protocol status:
•
Enable (globally enabled).
•
Disable (globally disabled).
Number of RRPP domains configured.
RRPP domain ID.
Control VLANs of the RRPP domain: Major and Sub.
List of VLANs protected by the RRPP domain. Multiple Spanning Tree
Instances (MSTIs) are displayed here. To get the VLANs corresponding to
these MSTIs, use the display stp region-configuration command.
Hello Timer value in seconds.
Fail Timer value in seconds.
RRPP ring ID.
RRPP ring level
•
0 representing primary ring.
•
1 representing subring.
Node mode.
•
Primary port when the node mode is master node or transit node.
•
Common port when the node mode is edge node or assistant edge
node.
•
A hyphen (-) appears when the port is not configured on the ring or the
board to which the port belongs does not start.
•
Secondary port when the node mode is master node or transit node.
•
Edge port when the node mode is edge node or assistant edge node.
•
A hyphen (-) appears when the port is not configured on the ring or the
board to which the port belongs does not start.
RRPP ring status:
•
Yes indicates enabled.
•
No indicates disabled.
GE1/0/5
60
Yes