Smart-Link Flush Enable - HP 6125G Command Reference Manual

View
User view
Default level
2: System level
Parameters
None
Description
Use reset smart-link statistics to clear flush message statistics.
Examples
# Clear flush message statistics.
<Sysname> reset smart-link statistics

smart-link flush enable

Syntax
smart-link flush enable [ control-vlan vlan-id-list ]
undo smart-link flush enable [ control-vlan vlan-id-list ]
View
Layer 2 Ethernet interface view, Layer 2 aggregate interface view
Default level
2: System level
Parameters
control-vlan vlan-id-list: Specifies the control VLANs used for receiving flush messages. The vlan-id-list is
expressed in the form of vlan-id-list = { vlan-id [ to vlan-id ] }&<1- 1 0>, where the vlan-id argument
represents the ID of a control VLAN and ranges from 1 to 4094. &<1- 1 0> indicates that you can provide
up to ten VLAN IDs or VLAN ID lists.
Description
Use smart-link flush enable to configure a receive control VLAN—a VLAN for receiving flush messages.
Use undo smart-link flush enable to disable flush message processing.
By default, flush messages are not processed.
If no VLAN is specified, VLAN 1 applies.
Do not use this command on the member port of an aggregation group or service loopback group.
Related commands: flush enable.
Examples
# Enable GigabitEthernet 1/0/1 to process the flush messages received in VLAN 1.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] smart-link flush enable
# Enable Layer 2 aggregate interface 1 to process the flush messages received in VLAN 1.
<Sysname> system-view
83