Dldp Configuration Commands; Display Dldp - HP 6125G Command Reference Manual

DLDP configuration commands

display dldp

Syntax
display dldp [ interface-type interface-number ] [ | { begin | exclude | include } regular-expression ]
View
Any view
Default level
1: Monitor level
Parameters
interface-type interface-number: Specifies a port by its type and number.
|: Filters command output by specifying a regular expression. For more information about regular
expressions, see Fundamentals Configuration Guide.
begin: Displays the first line that matches the specified regular expression and all lines that follow.
exclude: Displays all lines that do not match the specified regular expression.
include: Displays all lines that match the specified regular expression.
regular-expression: Specifies a regular expression, a case-sensitive string of 1 to 256 characters.
Description
Use display dldp to display the DLDP configuration of a port.
If no port is specified, this command displays the DLDP configuration of all DLDP-enabled ports.
Examples
# Display the DLDP configuration of all the DLDP-enabled ports.
<Sysname> display dldp
DLDP global status : enable
DLDP interval : 5s
DLDP work-mode : enhance
DLDP authentication-mode : simple, password is ******
DLDP unidirectional-shutdown : auto
DLDP delaydown-timer : 2s
The number of enabled ports is 2.
Interface GigabitEthernet1/1/3
DLDP port state : advertisement
DLDP link state : up
The neighbor number of the port is 1 (the maximum number ever detected is 2).
Neighbor mac address : 0000-0000-0100
Neighbor port index : 79
Neighbor state : two way
49