Preemption Mode; Protected-Vlan - HP 6125G Command Reference Manual

Description
Use preemption delay to set the preemption delay. When role preemption is enabled, after the
preemption delay is set, the master port waits for a specific period before taking over to collaborate with
the switchover of upstream devices.
Use undo preemption delay to restore the default.
By default, the preemption delay is 1 second.
The preemption delay configuration takes effect only after role preemption is enabled.
Related commands: preemption mode.
Examples
# Enable role preemption and set the preemption delay to 10 seconds.
<Sysname> system-view
[Sysname] smart-link group 1
[Sysname-smlk-group1] preemption mode role
[Sysname-smlk-group1] preemption delay 10

preemption mode

Syntax
preemption mode role
undo preemption mode
View
Smart link group view
Default level
2: System level
Parameters
role: Configures the role preemption mode, which enables the master port to preempt the slave port in
active state.
Description
Use preemption mode to enable role preemption.
Use undo preemption mode to disable role preemption.
By default, the device is operating in non-preemption mode.
Examples
# Enable the role preemption mode.
<Sysname> system-view
[Sysname] smart-link group 1
[Sysname-smlk-group1] preemption mode role

protected-vlan

Syntax
protected-vlan reference-instance instance-id-list
81