Rrpp Configuration Commands; Control-Vlan - HP 6125G Command Reference Manual

High availability command reference
Hide thumbs Also See for 6125G:
Table of Contents

Advertisement

RRPP configuration commands

control-vlan

Syntax
control-vlan vlan-id
undo control-vlan
View
RRPP domain view
Default level
2: System level
Parameters
vlan-id: ID of the primary control VLAN for the RRPP domain, which ranges from 2 to 4093. The specified
VLAN must be a new one (not yet created).
Description
Use control-vlan to configure the primary control VLAN for the current RRPP domain.
Use undo control-vlan to remove the control VLAN configurations for the current RRPP domain.
By default, no primary control VLAN exists in the RRPP domain.
When configuring control VLANs for an RRPP domain, you only need to configure the primary control
VLAN. The system automatically configures the secondary control VLAN, and it uses the primary control
VLAN ID plus 1 as the secondary control VLAN ID. For the control VLAN configuration to succeed, make
sure the IDs of the two control VLANs are consecutive and have not been assigned yet.
To ensure proper forwarding of RRPPDUs, do not configure the default VLAN of a port accessing an RRPP
ring as the control VLAN, or enable 802.1Q in 802.1Q (QinQ) or VLAN mapping on the control VLANs.
Before configuring RRPP rings for an RRPP domain, you can delete or modify the control VLANs
configured for the RRPP domain. However, after configuring RRPP rings for an RRPP domain, you cannot
delete or modify the control VLANs of the domain. You can only use the undo control-vlan command to
delete a control VLAN.
Related commands: rrpp domain.
Examples
# Configure VLAN 100 as the primary control VLAN of RRPP domain 1 (assume that VLAN 100 and
VLAN 101 have not been created yet).
<Sysname> system-view
[Sysname] rrpp domain 1
[Sysname-rrpp-domain1] control-vlan 100
58

Advertisement

Table of Contents
loading

This manual is also suitable for:

6125 blade switch series

Table of Contents