HP 6125G Command Reference Manual page 98

Field
Master IP
VRRP Track Information
Track Interface
Track Object
State
Pri Reduced
Switchover
# When VRRP operates in load balance mode, display brief information about all VRRP groups on the
router.
<Sysname> display vrrp
IPv4 Standby Information:
Run Mode
Run Method
Total number of virtual routers : 1
Interface
----------------------------------------------------------------------
Vlan2
-----
Table 30 Command output (load balancing mode)
Field
Run Mode
Description
Primary IP address of the interface where the router in the state of master
resides.
Information about the tracked interface or object. It is displayed only
when the vrrp vrid track or vrrp vrid track interface command is
executed.
Interface to be tracked. It is displayed only when the vrrp vrid track
interface command is executed.
Track entry to be tracked. It is displayed only when the vrrp vrid track
command is executed.
State of the tracked interface or track entry.
State of a tracked interface:
•
Up
•
Down
•
Removed
State of a track entry:
•
Invalid
•
Negative
•
Positive
•
Not existing
The priority value that is reduced when the monitored interface is down
or removed, or when the status of the monitored track entry turns to
negative. It is displayed only when the vrrp vrid track interface command
or the vrrp vrid track command is executed.
Switchover mode. When the status of the monitored track entry turns to
negative, the backup immediately switches to the master.
: Load Balance
: Virtual MAC
VRID State
1 Master
VF 1 Active
Description
Current VRRP operation mode:
•
Standard—Standard protocol mode.
•
Load Balance—Load balancing mode.
93
Run Address
Pri
140 1.1.1.1
255 000f-e2ff-0011
Active
Local
Local