Domain Ring - HP 6125G Command Reference Manual

Field
Active Status
Primary Port
Secondary Port
Common Port
Edge Port
Port status

domain ring

Syntax
domain domain-id ring ring-id-list
undo domain domain-id [ ring ring-id-list ]
View
RRPP ring group view
Default level
2: System level
Parameters
domain-id: RRPP domain ID, which ranges from 1 to 8.
ring-id-list: RRPP subring ID list expressed in the format of ring-id-list={ ring-id [ to ring-id ] }&<1- 1 0>,
where the ring-id argument is an RRPP subring ID in the range of 1 to 64 and &<1- 1 0> indicates that you
can input up to ten RRPP ring ID ranges.
Description
Use domain ring to configure subrings for an RRPP ring group.
Use undo domain ring to remove the specified subrings from an RRPP ring group. If no subring ID list is
specified, all subrings in the ring group are removed in the specified domain.
Description
RRPP ring activation status. An RRPP ring can be active only when the RRPP
protocol and the RRPP ring are both enabled. You can also use this field to
identify whether the RRPP protocol are enabled. Two statuses are available:
•
Yes for active.
•
No for inactive.
The primary port field means the node mode is master node or transit node.
A hyphen (-) appears when the port is not configured on the ring or the
board to which the port belongs does not start.
The secondary port field means the node mode is master node or transit
node. - appears when the port is not configured on the ring or the board to
which the port belongs does not start.
The common port field means the node mode is edge node or assistant edge
node. A hyphen (-) appears when the port is not configured on the ring or
the board to which the port belongs does not start.
The edge port field means the node mode is edge node or assistant edge
node. A hyphen (-) appears when the port is not configured on the ring or
the board to which the port belongs does not start.
Port status includes down, up and blocked; a hyphen (-) appears in one of
the following cases:
•
The ring is inactive.
•
The port is not configured on the ring.
•
The board to which the port belongs does not start.
67