Vrrp Ipv6 Vrid Weight Track - HP 6125G Command Reference Manual

[Sysname-Vlan-interface2] vrrp ipv6 vrid 1 virtual-ip 1::10

vrrp ipv6 vrid weight track

Syntax
vrrp ipv6 vrid virtual-router-id weight track track-entry-number [ reduced weight-reduced ]
undo vrrp ipv6 vrid virtual-router-id weight track [ track-entry-number ]
View
Interface view
Default level
2: System level
Parameters
virtual-router-id: VRRP group number, which ranges from 1 to 255.
track track-entry-number: Specifies a track entry to be monitored by its number, in the range of 1 to 1024.
reduced weight-reduced: Specifies the value by which the weight decreases, in the range of 1 to 255.
The default setting is 30.
Description
Use vrrp ipv6 vrid weight track to specify the track entry to be monitored by VFs when VRRP operates in
the load balancing mode. If the status of the monitored track entry changes to negative the weights of the
all VFs in the VRRP group to which the current router belongs decrease by a specified value.
Use undo vrrp ipv6 vrid weight track to cancel the specified track entry.
By default, no track entry is specified to be monitored.
The command is effective only when VRRP operates in load balancing mode.
Before executing the command, create a VRRP group on an interface and configure the virtual IPv6
address of the VRRP group.
When the status of the monitored track entry turns from negative to positive or invalid, the corresponding
VFs automatically restore their weights.
The track entry specified in this command can be nonexistent. You can use the vrrp ipv6 vrid weight track
command to specify a track entry, and then create the track entry with the track command.
By default, the weight of a VF is 255, and its lower limit of failure is 10.
If the weight of a VF owner is higher than or equal to the lower limit of failure, the priority of the VF owner
is always 255 and does not change with the weight value. Therefore, when an uplink fails, another VF
takes over the VF owner and becomes the AVF only when the weight of the VF owner decreases by a
properly specified value and becomes lower than the lower limit of failure, which means the weight of the
VF owner decreases by more than 245.
For more information about track entries, see High Availability Configuration Guide.
Related commands: display vrrp ipv6.
Examples
# Configure to monitor track entry 1, making the weights of VFs that belong to VRRP group 1 on
VLAN-interface 2 decrease by 50 when track entry 1 turns to negative.
<Sysname> system-view
131