Configuring Rip Parameters; Enabling Rip; Enabling Rip On The Routing Switch And Entering The Rip Router Context - HP 2920 Series Multicast And Routing Manual

Table 6 RIP interface parameters (continued)
Parameter
IP address
loop prevention
receive
send

Configuring RIP parameters

Use the following procedures to configure RIP parameters on a system-wide and individual VLAN
interface basis.

Enabling RIP

RIP is disabled by default. To enable it, use one of the following methods. When you enable RIP,
the default RIP version is RIPv2-only. You can change the RIP version on an individual interface
basis to RIPv1 or RIPv1-or-v2, if needed.
To enable RIP on a routing switch, enter the following commands:
HP Switch(config)# ip routing
HP Switch(config)# router rip
HP Switch(rip)# exit
HP Switch(config)# write memory
NOTE: IP routing must be enabled prior to enabling RIP. The first command in the preceding
sequence enables IP routing.

Enabling RIP on the routing switch and entering the RIP router context

Syntax:
[no] router rip [[enable] | [disable]] [auto-summary]
Executed at the global configuration level to enable RIP on the routing switch and
to enter the RIP router context. This enables you to proceed with assigning RIP areas
52 IP Routing Features
Description
This parameter applies only to RIP
routes.
The routes that a routing switch learns
or advertises can be controlled.
The method the routing switch uses to
prevent routing loops caused by
advertising a route on the same
interface as the one on which the
routing switch learned the route:
Split horizon — The routing switch
does not advertise a route on the
same interface as the one on which
the routing switch learned the
route.
Poison reverse — The routing
switch assigns a cost of 16
"infinite" or "unreachable") to a
route before advertising it on the
same interface as the one on which
the routing switch learned the
route.
Define the RIP version for incoming
packets
Define the RIP version for outgoing
packets
Default
The routing switch learns and advertises
all RIP routes on all RIP interfaces
Poison reverse
V2-only
V2-only