Printing Non-Standard Sized Originals - Oce 9800 User Manual

Printing non-standard sized originals

The following default print settings are usually overruled by settings that
Note:
are sent to the printer along with the print job.
The Océ 9800 determines the length and width of each digital original.
The Océ 9800 has three cut options:
Standard cut, which cuts copies to a standard length. The system cuts at the
predicted length, which is based on the measured standard width.
Synchro cut, which cuts copies at the end of the image. The system cuts at
the measured length of the original, and
Custom cut, which cuts copies to a specified length. See 'Defining your copy
length' on page 42.
When printing non-standard sized originals, use 'Synchro cut' or 'Custom
cut'.
When folding copies of non-standard sized originals, two restrictions apply:
Copies between 2,5 m and 6 m in length (approx. 8' and 20' respectively)
cannot be processed by the second fold unit (fan-fold only), and must be
collected from the first fold unit (see figure 107 on page 111).
Copies that would exceed the maximum length are cut to 6 m (approx. 20'),
to prevent jams in the folder.
Selecting default settings to print non-standard sized originals
Open the 'Copy size' card in the 'Copy' section.
1
Press the 'Copy length' function button to select 'Synchro cut', 'Standard cut'
2
or 'Custom cut' (see figure 32).
Prints:
Ready to print
0
Image
Copy
1
media
......................................................................................................................................
Copy
size
[32] Copying with standard cut
Default printer settings
................ ................
Machine
A4 >> A2
A3 >>
A2
210 mm
A2
A2 >>
A2
A1 >> Standard cut
A2
A0 >> Synchro cut
Copy
Auto format
selection selection length
................
................
Program Finishing
Copy
Margin
(mm)
41