Mmc: 603 Assign Trunk Group - Samsung DCS Programming Manual

DCS
COMBINED PROGRAMMING MANUAL
MMC: 603
3 3
DCS
Allows the assignment of trunks to a specific trunk group or to several trunk groups. This is very
useful for programming of LCR when more than one trunk is to be in several dialling plans. There
are two different modes of operation: (1) sequential and (2) distribute.
WARNING: One trunk can appear in more than one trunk group. If necessary, delete the trunk
member from other groups to prevent accidental access.
The number of trunk groups is:
DCS and Compact II — 11: valid groups are 9 and 80–89.
816 — Four: valid groups are 9 and 80–82.
408/408i — Two: valid groups are 9 and 8.
Valid number of members of trunk groups are:
DCS:
Compact I:
Compact II:
816:
408/408i:
PROGRAM KEYS
UP & DOWN
KEYPAD
SOFT KEYS
SPEAKER
HOLD
ANS/RLS
ACTION
1. Open programming and select 603
Display shows (e.g. trunk group 9)
2. Enter in valid trunk group (see above)(e.g. 81)
OR
Press UP or DOWN key to make selection and press
RIGHT soft key to advance cursor
3. Press RIGHT soft key to change mode
OR
Press UP or DOWN key to change mode to member
4. Press RIGHT soft key to move cursor to number of
member and enter valid member number (e.g. 04) via
dial keypad
OR
Press UP or DOWN key to make selection and press
RIGHT soft key to move cursor
ASSIGN TRUNK GROUP
3 3
CI CII
01–80
01–10
01–40
01–10
1–4
Used to scroll through options
Used to enter selections
Move cursor left and right
Used to store data and advance to next MMC
Used to clear previous entry
Used to select ALL
MMC 603 (Page 1 of 2)
3 3 3 3
816 408i
DISPLAY
[9] TRK GROUP
MODE:SEQUENTIAL
[81] TRK GROUP
MODE:SEQUENTIAL
[81] TRK GROUP
MEMBER 01:NONE
[81] TRK GROUP
MEMBER 04:NONE
MMC PROGRAMS
NOVEMBER 2001
3 3 3 3
408