Mmc: 804 System I/O Parameter - Samsung DCS Programming Manual

DCS
COMBINED PROGRAMMING MANUAL
MMC: 804
3 3
DCS
Provides a means of setting parameters for the system I/O ports to work with one of the follow-
ing:
a personal computer (PC)
Station Message Detail Recording (SMDR)
UCD statistics report/periodic UCD information (except 408/408i)
CTI (TSAPI) interface (DCS and Compact II only).
All systems have two I/O ports (Ports 1 and 2), except 408/408i which have one I/O port (Port 1).
Programming can be accomplished easily, using the tables below to customise any I/O port.
PARAMETER OPTIONS
Dial 0 Service
Dial 1 Baud Rate
Dial 2 Char Length
Dial 3 Parity
Dial 4 Retry Count
Dial 5 Stop Bit
Dial 6 Wait Time
Dial 7 DSR Check
or
SIM Pair
SERVICE TYPE
Each port can be set to one of the following service types. Note that the services available depend on
the type of system being programmed. For example, DCS and CII systems provide all the following
services while 408/408i systems provide PC-MMC and SMDR only.
Type
PC-MMC
SMDR
UCD REPT
UCD/SMDR
CTI
CTI/SMDR
CTI/UCD
CTI/S/U
VM TRACE
NOT USE
SYSTEM I/O PARAMETER
3 3
CI CII
Type of Service
Speed
Character Length
Parity Bit
Number of Retries
Stop Bit
Message Wait Time
DSR Check on/off (Compact II, 816 and 408/408i only)
No. of the station connected to the Serial Interface Module
(SIM) (DCS only)
Description
PC application
SMDR report (call logging)
UCD report on request by the
supervisor, or daily
Both SMDR and UCD report will
be generated
Dedicated Switch Link Interface
CTI and SMDR
CTI and UCD
CTI, SMDR and UCD
Voice Mail monitoring
Not used
MMC 804 (Page 1 of 3)
3 3 3 3 408i
816
MMC PROGRAMS
NOVEMBER 2001
3 3 3 3
408