Keys Used For Programming; Station Level; Soft Keys; Other Keys - Samsung DCS Programming Manual

DCS
COMBINED PROGRAMMING MANUAL

1.3.3 Station Level

The system administrator or keyset user can access certain programs at a station with-
out using a passcode. At this level, only data for the selected station can be changed.
You should refer to the instructions provided in the Samsung DCS Keyset User Guide.
Accessible MMCs at this level are nos. 100–121.

1.4 Keys Used for Programming

Programming may be done from any 6-button (6B), 12-button (12B) or 24-button (24B)
keyset with a liquid crystal display (LCD). (Refer to the Samsung DCS Keyset User Guide
for a full description of keyset operation.)

1.4.1 Soft Keys

The three keys directly below
the LCD are called soft keys.
The left-hand soft key is desig-
nated as the LEFT soft key. This
key is used to save any
changed data while program-
ming, or to move the cursor to
the left on the LCD.
The right-hand soft key is des-
ignated as the RIGHT soft key.
This key is used to save any
changed data while program-
ming, or to move the cursor to
the right on the LCD.

1.4.2 Other Keys

The following keys perform special functions:
VOLUME UP (+) / DOWN (–)
KEYPAD
HOLD
ANS/RLS
SPEAKER
TRSF
* Note: Many MMCs allow you to dial codes using the keypad to select options quickly. Alterna-
tively, you can press the VOLUME Up and Down keys (+ and – ) to scroll through and select op-
tions. Use whichever method you prefer.
Scroll up/down through available options*
Enter data using keys 0–9 and [, and dial options*
Clear previous entry
Select "ALL" option (e.g. to make data apply to all,
rather than selected, stations)
Store data and advance to next MMC
Enter programming mode or
Store data and exit programming mode
1-3
INTRODUCTION
NOVEMBER 2001
DCS Euro Display Keysets