Mmc: 810 Halt Processing - Samsung DCS Programming Manual

DCS
COMBINED PROGRAMMING MANUAL
MMC: 810
3 3
DCS
Used only in the event that all data processing needs to be stopped in either a single cabinet or
slot, or in the entire system. The procedure differs slightly between systems.
Note: You do not need to enable system programming (MMC 800) in order to run this program but you will
still require the technician's passcode.
PROGRAM KEYS
UP & DOWN
KEYPAD
SOFT KEYS
SPEAKER
ANS/RLS
DCS PROCEDURE
n
ACTION
1. Open programming and select 810
Display shows
2a. Enter cabinet selection via dial keypad
OR
Press UP or DOWN key to make selection and press
RIGHT soft key to advance cursor
2b. Press ANS/RLS to select all cabinets and all slots
3. Enter slot number via dial keypad
OR
Press UP or DOWN key to make selection and press
RIGHT soft key to advance cursor
4. Enter 1 for HALT or 0 to PROC
OR
Press UP or DOWN key to make selection and press
RIGHT soft key to enter data and return to step 2
5. Press TRSF to store and exit
OR
Press SPEAKER to store and advance to next MMC
HALT PROCESSING
3 3 3 3
CI CII
Used to scroll through options
Used to enter selections
Move cursor left and right
Used to store data and advance to next MMC
Used to select ALL
MMC 810 (Page 1 of 2)
3 3 7 7
816 408i
DISPLAY
HALT/PROCESSING
C:ALL S:ALL PROC
HALT/PROCESSING
C:3 S:ALL
HALT/PROCESSING
C:ALL S:ALL PROC
HALT/PROCESSING
C:3 S:5
HALT/PROCESSING
C:3 S:5
MMC PROGRAMS
NOVEMBER 2001
7 7
408
PROC
PROC
HALT