Setting Up The Phaser 790; Preparing For The Installation; Selecting A Location - Xerox Phaser 790 Documentation

1
This chapter contains the hardware installation instructions only. To install
the printer driver software, go to the
install to the network, go to the appropriate chapter for your operating system.

Preparing for the installation

Before you begin the installation of your Xerox Phaser 790, read this entire
section. You must locate an appropriate site for the installation of the Phaser
790 Printer. Reading this section assists you with the decision making
process.

Selecting a location

WARNING
The wall outlet must be rated for 115 or 240 volts. It must also be protected
for at least 15 amps for 115 volts, or 8 amps for 240 volts. If you are in
doubt about a power source, ensure that a qualified electrician checks the
outlet.
Do not connect any other devices to the wall outlet designated for the Xerox
Phaser 790.
Install the Xerox Phaser 790 in a location that meets the following conditions:
The Phaser 790 has a designated wall outlet.
The power cord cannot be stepped on, or be a tripping hazard.
The location has a level, stable surface.
DO NOT install the Phaser 790 in a location that has any of the following
conditions:
In direct sun light
In a dusty place
In a windy place
Where it might be subject to
vibration
Where abrupt changes in temperature or humidity occur
Xerox Phaser 790

Setting up the Phaser 790

Installing your user software
Near an air conditioner or heater
Near an open flame
Near water
Near a magnetic field
chapter. To
1-1