Xerox Phaser 790 Documentation page 63

Installing the Duplex Tray
b.
c.
CAUTION
Use caution if you must rearrange the tiny wires on the connector in order to
close the Connector Cover.
Xerox Phaser 790
Connect the tiny connector on the rear of the Upper Inverter to the
small jack in the access hole, as shown below.
Install the new Connector Cover with the cutout into the access
hole, guiding the wires through the cutout in the cover.
1. Setting up the Phaser 790
0301062b
0 301132A-WOL
301063b
0 301133A-WOL
1-39