Performing The Setup From The Printer Control Panel; Set Up The Print Functions - Xerox Phaser 790 Documentation

7
Initial printer setup for network printing must be performed at the
Printer Control Panel. The control panel on the top of the printer
enables you to set options and view the status of the printer and print
jobs. This chapter enables you to perform the following functions:

Set up the print functions

Specify network information and network protocol options
Perform Network Services Setup
Print information pages
After network communication settings have been established, you can
specify additional Setup options from a client workstation using
WebSetup. Refer to the chapter Performing the setup from WebSetup
for more information.
Set up the print functions
Follow the procedures in this section for initial setup or to change setup
information at the printer.
1. Power on the printer and press the Menu button when the
message Ready or Power Saver On is displayed.
2. Before you change the setup, print the current Configuration page
in case you need to restore the original settings later.
a.
b.
c.
Xerox Phaser 790
Performing the setup from the
Press the Menu button on the printer control panel until the
message Print Pages from List is displayed.
Press the Item/Enter button to display Print Configuration.
Press Item/Enter to print the page.
Printer Control Panel
7–1