Preparing for the installation
Checking the installation components
Ensure that each of the components you ordered are available before you
begin the installation. All of the componets are listed below.
Printer
Printer Cabinet (optional)
Duplex Tray (optional)
2 Tray Module (optional)
You may need a phillips head and a flat blade screwdriver in order to
perform the installation of the Phaser 790.
Following the instructions ensures that the Phaser 790 componets are
installed in the following order:
1.
Printer Cabinet, if ordered
2.
2 Tray Module, if ordered
3.
Printer
4.
Duplex Tray, if ordered
5.
Accessories, if ordered
6.
Client Software (customer installed)
The first step
If the Phaser 790 was installed for you, go to
Xerox Phaser
If you ordered the optional 2 Tray Module, go to the
Cabinet
procedure.
If you ordered the optional 2 Tray Module, go to the
Module
procedure.
If you do not have a 2 Tray Module, go to the
Xerox Phaser 790
790.
1. Setting up the Phaser 790
Chapter 2. Getting to know the
Setting up the Printer
Installing the 2 Tray
Upacking the Printer
procedure.
1-3