Windows 95/98; Before You Begin; Installing The Print Driver - Xerox Phaser 790 Documentation

Windows 95/98 print drivers

Windows 95/98

Before you begin

1. Ensure that the Phaser 790 has been prepared for network printing.
2. Ensure that you have the printer name, Apple Talk Zone (if applicable),
and IP Address. These may be obtained from your system administrator
or from the Configuration Page.
In order to print the Configuration Page, perform the following steps:
a.
b.
c.
d.

Installing the print driver

The following procedure provides the steps for installing the printer driver for
parallel port printing. For detailed information about setting up IPX/SPX
printing or SMB printing, refer to Installing the user software in a Windows
95/98 environment.
1. Insert the User Software CD in your CD-ROM drive.
2. Select the Start button, Settings, and Printers.
3. Double-click the Add Printer and select Next.
4. Select Local printer and Next.
5. Select the Have Disk button.
6. Perform one of the following:
Xerox Phaser 790
Press the Offline button on the Printer Control Panel
Press the Menu button until the message Print Pages from List is
displayed on the Printer Control Panel.
Press the Item/Enter button in order to select Print Configuration
Page.
Press the Item/Enter again button in order to print the page.
If you are installing from the CD, select the CD-ROM drive (for
example, D:\) from the drop-down box and select the Browse
button.
If you are installing from files you downloaded using the Installer
WebTool, type the name of your hard disk drive (for example, C:\)
and select the Browse button.
3. Network Setup
3-5