Setting Print Options For All Postscript Jobs (Windows Nt 4.0); Setting Print Options For A Pcl Job (Windows Nt 4.0) - Xerox Phaser 790 Documentation
Xerox printers documentation
Hide thumbs
Also See for Phaser 790:
- Service manual (653 pages) ,
- Getting started manual (83 pages) ,
- Brochure & specs (4 pages)
Table of Contents
Advertisement
14. Printing from the Windows workstations
Setting print options for all PostScript jobs
(Windows NT 4.0)
1.
Select Start, Settings, and Printers.
2.
Right-click to select the Xerox Phaser 790 PCL printer icon and
select Document Defaults.
3.
Select the Fiery Printing tab.
4.
Specify the appropriate default settings for all print jobs as
described in the previous procedure.
5.
Select OK.
With the PCL printer driver, you can set options on a job-by-job
basis or establish default settings for all jobs printed from your
workstation to the Phaser 790.
Setting print options for a PCL job (Windows NT 4.0)
1.
Select Print in your application.
2.
Select the Xerox Phaser 790 PCL printer icon and select
Properties from the File menu.
3.
Select the Fiery Printing tab.
This tab serves as the control center for all frequently used
printing functions.
4.
Select the Paper Source print option bar.
a.
b.
c.
For more information on these and other print options, refer to the
chapter Print options.
If paper loaded in the selected tray is a different size, orientation, and/or
media type than that of the job you are sending, the printer displays an error
message and the job might not print. Load the correct paper in the selected
tray or cancel the job.
14–18
In the Page Size area, specify the paper size for the job.
In the Paper Source area, select the paper tray for the job.
In the Media Type area, select the type of media to use for
the job.
Xerox Phaser 790
Advertisement
Table of Contents
