Xerox Phaser 790 Documentation page 394

21. Performing the setup from WebSetup
5. Select the Enable on Token Ring check box if you have a
Token Ring network connected to the printer over Ethernet
cabling. If the check box is selected, the IP Auto and IP Static
radio buttons are enabled.
a.
b.
21–14
Select the IP Auto radio button to enable the system to find
an IP address. Select the appropriate protocol to be used
from the enabled Select Protocol drop down box.
To set a specific address, select the IP Static radio button to
enable the IP Address and Subnet Mask fields and perform
the following:
Enter the Phaser 790 unique IP address for Ethernet in the
IP Address text boxes (default address used for network
checking is 127.000.000.001). The values in each field are
limited to a range of 0-255.
Enter one of the following values in the Subnet Mask text
boxes:
255.0.0.0 if the IP address starts with a number less
than 128
255.255.0.0 if the IP address starts with a number in
the range of 128—191
255.255.255.0 if the IP address starts with a number
greater than 191 (network defined)
Xerox Phaser 790