Tcp/Ip; Enabling Tcp/Ip At The Printer Control Panel - Xerox Phaser 3330 System Administrator Manual

Network Connectivity

TCP/IP

This section includes:
•

Enabling TCP/IP at the Printer Control Panel ............................................................................................................ 20

• Configuring the Network Address Manually at the Control Panel ................................................................... 21
• Configuring IP Settings in Xerox
Computers and printers primarily use TCP/IP protocols to communicate over an Ethernet network.
Generally, Macintosh computers use either TCP/IP or the Bonjour protocol to communicate with a
network printer. For Macintosh OS X systems, TCP/IP is preferred. Unlike TCP/IP, however, Bonjour
does not require printers or computers to have IP addresses.
With TCP/IP protocols, each printer and computer must have a unique IP address. Many networks
and cable and DSL routers have a Dynamic Host Configuration Protocol (DHCP) server. A DHCP server
automatically assigns an IP address to every computer and printer on the network that is configured
to use DHCP.
If you use a Cable or DSL router, see the documentation for your router for information on IP addressing.
Enabling TCP/IP at the Printer Control Panel
Note: By default, TCP/IP is enabled. If you disable TCP/IP, enable it at the printer control panel
before you access Xerox
At the printer control panel, press the Menu button.
1.
2. Navigate to Tools, then press OK.
Navigate to Setup, then press OK.
3.
4. Navigate to Network Settings, then press OK.
5. To enable TCP/IPv4, navigate to TCP/IPv4, then press OK.
Navigate to IPv4, then press OK.
a.
b. Navigate to On, then press OK.
To enable TCP/IPv6, navigate to TCP/IPv6, then press OK.
6.
a. Navigate to IPv6, then press OK.
b. Navigate to On, then press OK.
20 Xerox Phaser 3330 Printer
® ®
System Administrator Guide
® CentreWare ®
® CentreWare ® Internet Services.
Internet Services.................................................................. 21