3.2
Communication Parameter Setup
(Printer Control Panel)
This section explains the procedures for setting up the communication parameters from
the printer control panel.
Procedure
MENU
PORT SETTING
PORT SETTING
TCP/IP
TCP/IP
Ethernet Setting
Ethernet Setting
AUTO
SNMP must be set up from Print Services on Web.
The changed parameters become valid after the machine is rebooted.
*
1
Press the <
> key with [PORT SETTING]
displayed.
2
Select the interface that is to be set up with the
use of the < > and < > keys, and then press
the <
> key.
[TCP/IP], [SERIAL], [CENTRO], and [VPI]
will be displayed, in that order.
[CENTRO] and [VPI] are optional.
3
Select the parameters with the use of the < >
and < > keys, and then press the <Set> key.
An asterisk [*] will be displayed on the right
side of the value once it has been set up.
The changed parameters are saved to the
system when the <Set> key is pressed. It
is not necessary to save each change
individually.
Refer to the previous section for detailed
information about each of the
communication parameters.
4
After setting up all of the parameters, switch the
printer power off and then on for the changes to
take effect.