Table of Contents
Advertisement
6.6
When an Error Message is
Displayed
This section explains the meaning of the error messages that appear on the display panel
and the solutions for these messages.
There are two types of error messages, namely, warning messages to get your attention
and printing can still be done, and error messages, where troubleshooting needs to be done
to resolve an error.
When an error message appears, determine the cause and solution of the problem by using
the following tables.
If the length of the error message exceeds the space on the display panel, the display panel will take three seconds
to switch between the first part of the message and the second.
The diagram in the table shows a printer installed with the 2 tray module and the duplex module.
Message
***_***
Reboot Printer
Paper Jam Open Top Cover
Replace EP Cartridge
Warning message
Ready to Print
Need Replacement
Error message
Replace
EP Cartridge
Meaning and Solution
The printer does not function normally.
[Solution] Turn the printer power off, and turn it on again. If the
same message appears again, memo the displayed
contents, and turn the power off. Then contact your
FujiXerox or dealers.
Paper jam occurred behind the EP cartridge.
[Solution] Open the top cover, pull out the EP cartridge, then
remove the jammed paper.
"7.1.3 Removing Paper Jammed Near the Fuser Unit"
The EP cartridge is at the end of its life.
[Solution] Replace the EP cartridge with a new one.
"8.1 Replacing the EP cartridge (Drum/Toner Cartridge)"
Printing is possible
Printing is not possi-
ble until the error
state is released.
6
137
Advertisement
Table of Contents
