Front Cover Errors
Error Indicated When Front Cover is Closed
Phaser 3140/3155/3160 Printer Service Manual
Downloaded From ManualsPrinter.com Manuals
The Status LED indicates an error even though the Front Cover is closed.
Initial Actions
•
Cycle printer power.
•
If the problem persists, refer to the following procedure.
Troubleshooting Reference Table
Applicable Parts
Front Cover, PL1.0.11
Power Supply Board, PL1.0.1
Troubleshooting Procedure Table
Step
Actions and Questions
1
Check that the Front Cover open
actuator (PL6,0.55) is securely
affixed to the frame.
Is the actuator firmly attached?
2
Inspect the Front Cover for damage.
Is the Front Cover damaged?
3
Replace the Power Supply Board
(page 8-54).
Error Messages and Codes
Wiring and Plug/Jack Map References
Map 5 - Sensors
Yes
No
Go to step 2.
Tighten the
actuator screw.
If the problem
persists, go to
step 2.
Replace the
Go to step 3.
Front Cover.
If the problem
persists, go to
step 3.
Complete.
3-23