Cli Commands; Add - Avocent MERGEPOINT 53XX SP MANAGER Installer/User Manual

106 MergePoint Service Processor Manager SP53XX Installer/User Guide
Pressing
Tab
name, unless there is more than one parameter name beginning with the typed characters. If more
than one parameter name begins with the typed characters, then
NOTE: The bootconf and cards commands are only for MergePoint SP5324/SP5340 appliance.
Examples
cli> s<Tab><Tab>
set shell
cli> se<Tab>
cli> set
cli> set n<Tab><Tab>
network ntp
cli> set ne<Tab>
cli> set network
cli> set network <Tab><Tab>
hostname hosts interface resolv
cli> set network i<Tab>
cli> set network interface
cli> set network interface eth0 <Tab>
address alias
address6 broadcast gateway6 method6 mtu6 netmask6

CLI Commands

The CLI utility supports the commands that are described in the following sections with examples.
cli> <Tab><Tab>

add

cd
add
The add command adds the last parameter and sets it to the default value (if any). Any nondefault
values must be set using the
The add command is used instead of
example, add network hosts <IP address> makes an entry for a host with the specified IP address in
the hosts list. In that case, add is used because multiple hosts can exist.
once after partially typing a parameter name automatically completes the parameter
show
gateway method mtu netmask
commit exit
delete get
set command.
st_routes
list rename
quit revert
set when multiple parameters of the same type can exist. For
displays them all.
Tab Tab
set show
shell version